User manual

Chapter 6: Monitoring the System | 215
GS108T and GS110TP Smart Switch Software Administration Manual
Click Clear Counters to clear all the counters. This resets all statistics for the trap logs to the
default values.
Event Logs
Use the Event Log page to display the event log, which is used to hold error messages for
catastrophic events. After the event is logged and the updated log is saved in flash memory,
the switch will be reset. The log can hold at least 2,000 entries and is erased when an
attempt is made to add an entry after it is full. The event log is preserved across system
resets.
To access the Event Log page, click the Monitoring  Logs tab, and then click the Event
Logs link.
The following table describes the Event Log information displayed on the screen.
Field Description
Entry The number of the entry within the event log. The most recent entry is first.
Type Specifies the type of entry.
Filename The GS108T or GS110TP source code filename identifying the code that
detected the event.
Line The line number within the source file of the code that detected the event.
Task ID The OS-assigned ID of the task reporting the event.
Code The event code passed to the event log handler by the code reporting the
event.
Time The time the event occurred, measured from the previous reset.
Use the buttons at the bottom of the page to perform the following actions:
• Click Clear to clear the messages out of the Event Log.
• Click Refresh to refresh the data on the screen and display the most current information.