User manual

24 | Chapter 1: Getting Started
GS108T and GS110TP Smart Switch Software Administration Manual
Understanding the User Interfaces
The switch software includes a set of comprehensive management functions for configuring
and monitoring the system by using one of the following methods:
• Web user interface
• Simple Network Management Protocol (SNMP)
Each of the standards-based management methods allows you to configure and monitor the
components of the switch software. The method you use to manage the system depends on
your network size and requirements, and on your preference.
The GS108T and GS110TP Smart Switch Software Administration Manual describes how to
use the Web-based interface to manage and monitor the system.
Using the Web Interface
To access the switch by using a Web browser, the browser must meet the following software
requirements:
• HTML version 4.0, or later
• HTTP version 1.1, or later
• Java Runtime Environment 1.6 or later
Use the following procedures to log on to the Web interface:
1. Open a Web browser and enter the IP address of the switch in the Web browser
address field.
2. The factory default password is password. Type the password into the field on the login
screen, as shown in
Figure 2 on page 17, and then click Login. Passwords are case
sensitive.
3. After the system authenticates you, the System Information page displays.
Figure 3 on page 25 shows the layout of the Smart Switch Web interface.