Quick Reference Guide

GS108T and GS110TP Smart Switch Software Administration Manual
3-56 Configuring Switching Information
v1.0, April 2010
To configure the Dynamic Address setting:
1. Specify the number of seconds the forwarding database should wait before deleting a learned
entry that has not been updated. IEEE 802.1D-1990 recommends a default of 300 seconds.
You may enter any number of seconds between 10 and 1000000. The factory default is 300.
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
3. Click Apply to apply to send the updated configuration to the switch. Configuration changes
take effect immediately.
Static MAC Address
Use the Static MAC Address Configuration page to configure and view static MAC addresses on
an interface.
To access the Static MAC Address Configuration page, click Switching Address Table 
Advanced  Static MAC Address.
Figure 3-37
Note: IEEE 802.1D recommends a default of 300 seconds, which is the factory
default.