Quick Reference Guide

GS108T and GS110TP Smart Switch Software Administration Manual
4-6 Configuring Quality of Service
v1.0, April 2010
To display the Interface Queue Configuration page, click the QoS  CoS tab, and then click the
Advanced  Interface Queue Configuration link.
To configure CoS queue settings for an interface:
1. To configure CoS queue settings for a physical port, click PORTS.
2. To configure CoS queue settings for a Link Aggregation Group (LAG), click LAGS.
3. To configure CoS queue settings for both physical ports and LAGs, click ALL.
4. Select the check box next to the port or LAG to configure. You can select multiple ports and
LAGs to apply the same setting to the selected interfaces. Select the check box in the heading
row to apply a trust mode or rate to all interfaces.
5. Configure any of the following settings:
• Queue ID. Use the menu to select the queue to be configured.
• Minimum Bandwidth. Enter a percentage of the maximum negotiated bandwidth for the
selected queue on the interface. Specify a percentage from 0–100, in increments of 1.
Figure 4-3