Quick Reference Guide

GS108T and GS110TP Smart Switch Software Administration Manual

Getting Started 1-21

v1.0, April 2010

3. To enable encryption, select the DES option in the Encryption Protocol field. Then, enter an

encryption code of eight or more alphanumeric characters in the Encryption Key field.

4. Click Apply.

To access configuration information for SNMPv1 or SNMPv2, click System  SNMP 

SNMPv1/v2 and click the page that contains the information to configure.

Interface Naming Convention

The GS108T and GS110TP support physical and logical interfaces. Interfaces are identified by

their type and the interface number. The physical ports are gigabit interfaces and are numbered on

the front panel. You configure the logical interfaces by using the software. Table 1-2 describes the

naming convention for all interfaces available on the switch.

Table 1-2. Types of Interface

Interface Description Example

Physical The physical ports are gigabit Ethernet

interfaces and are numbered sequentially

starting from one.

g1, g2, g3

Link Aggregation Group (LAG) LAG interfaces are logical interfaces that are

only used for bridging functions.

l1, l2, l3

LAG1, LAG2

CPU Management Interface This is the internal switch interface responsible

for the switch base MAC address. This interface

is not configurable and is always listed in the

MAC Address Table.