Quick Reference Guide

GS108T and GS110TP Smart Switch Software Administration Manual
2-10 Configuring System Information
v1.0, April 2010
To configure a new SNTP Server:
1. Enter the appropriate SNTP server information in the available fields:
• Server Type. Specifies whether the address for the SNTP server is an IP address (IPv4) or
hostname (DNS).
• Address. Enter the IP address or the hostname of the SNTP server.
• Port. Enter a port number on the SNTP server to which SNTP requests are sent. The valid
range is 1–65535. The default is 123.
• Priority . Specifies the priority of this server entry in determining the sequence of servers
to which SNTP requests are sent. Enter a priority from 1–3, with 1 being the default and
the highest priority. Servers with lowest numbers have priority.
• Version. Enter the protocol version number. The range is 1–4.
2. Click Add.
3. Repeat the previous steps to add additional SNTP servers. You can configure up to three SNTP
servers.
4. To removing an SNTP server, select the check box next to the configured server to remove,
and then click Delete. The entry is removed, and the device is updated.
Figure 2-4