Quick Reference Guide

GS108T and GS110TP Smart Switch Software Administration Manual
Configuring System Information 2-27
v1.0, April 2010
• Status. Specify the status of this community by selecting Enable or Disable from the pull
down menu. If you select Enable, the Community Name must be unique among all valid
Community Names or the set request will be rejected. If you select Disable, the
Community Name will become invalid.
2. To modify an existing community, select the check box next to the community, change the
desired fields, and then click Apply. Configuration changes take effect immediately.
3. To delete a community, select the check box next to the community and click Delete.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
Trap Configuration
This page displays an entry for every active Trap Receiver. To access this page, click System 
SNMP  SNMP V1/V2  Trap Configuration.
To configure SNMP trap settings:
1. To add a host that will receive SNMP traps, enter trap configuration information in the
available fields described below, and then click Add.
• Recipients IP. The address in x.x.x.x format to receive SNMP traps from this device.
Figure 2-15