Quick Reference Guide

GS108T and GS110TP Smart Switch Software Administration Manual
Configuring Switching Information 3-9
v1.0, April 2010
To configure LACP:
1. From the LACP System Priority field, specify the device’s link aggregation priority relative to
the devices at the other ends of the links on which link aggregation is enabled. A higher value
indicates a lower priority. You can change the value of the parameter globally by specifying a
priority from 0–65535. The default value is 32768.
2. Click Refresh to reload the page and display the most current information.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
4. If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.
LACP Port Configuration
To display the LACP Port Configuration page, click Switching LAG  Advanced  LACP
Port Configuration.
Figure 3-7