Owner's Manual
Table Of Contents
- User Manual
- Contents
- 1. Hardware
- 2. Get Started
- 3. Use VLANS for Traffic Segmentation
- 4. Optimize Performance With Quality of Service
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage Flow Control
- Manage the Port Speed and the Port Status
- Enable Loop Detection
- Manage Power Saving Options
- Download and Update the Firmware
- Reboot the Switch
- Save the Switch Configuration
- Restore a Saved Switch Configuration
- Restore Factory Default Settings
- Manage Access Control
- Enable Port Mirroring
- View Switch Information or Change the Switch Device Name
- View or Clear the Port Statistics
- PoE Considerations for Switches That Support PoE
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings and Technical Specifications
- Factory Default Settings
- Technical Specifications
- Model GS105Ev2 Technical Specifications
- Model GS105PE Technical Specifications
- Model GS108Ev3 Technical Specifications
- Model GS108PEv3Technical Specifications
- Model GS116Ev2 Technical Specifications
- Model GS305E Technical Specifications
- Model GS308E Technical Specifications
- Models JGS516PE and JGS524PE Technical Specifications
- Model JGS524Ev2 Technical Specifications
- Installation Guide
- Smart Managed Plus Gigabit Ethernet Switches
ensures that the data from the computer on port 6 can be seen only by other members
of VLAN 2. You can assign only one PVID to a port.
To assign a PVID to one or more ports:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 16.
The login window opens.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5.
Select VLAN > 802.1Q > Advanced > VLAN Configuration.
The Advanced 802.1Q VLAN Status page displays. The menu on the left displays
more options.
6.
Select Port PVID.
You can select Port PVID only if you already enabled the advanced 802.1Q VLAN
option (see Create 802.1Q-Based VLANs in an Advanced Configuration on page
33).
The previous figure is an example. Your switch might provide more or fewer ports.
7. Select one or more ports.
8. Enter the PVID.
You can enter a PVID only for a VLAN that already exists.
9.
Click the Apply button.
Your settings are saved.
User Manual37Use VLANS for Traffic
Segmentation
Gigabit Ethernet Smart Managed Plus Switches