Owner's Manual
Table Of Contents
- User Manual
- Contents
- 1. Hardware
- 2. Get Started
- 3. Use VLANS for Traffic Segmentation
- 4. Optimize Performance With Quality of Service
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage Flow Control
- Manage the Port Speed and the Port Status
- Enable Loop Detection
- Manage Power Saving Options
- Download and Update the Firmware
- Reboot the Switch
- Save the Switch Configuration
- Restore a Saved Switch Configuration
- Restore Factory Default Settings
- Manage Access Control
- Enable Port Mirroring
- View Switch Information or Change the Switch Device Name
- View or Clear the Port Statistics
- PoE Considerations for Switches That Support PoE
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings and Technical Specifications
- Factory Default Settings
- Technical Specifications
- Model GS105Ev2 Technical Specifications
- Model GS105PE Technical Specifications
- Model GS108Ev3 Technical Specifications
- Model GS108PEv3Technical Specifications
- Model GS116Ev2 Technical Specifications
- Model GS305E Technical Specifications
- Model GS308E Technical Specifications
- Models JGS516PE and JGS524PE Technical Specifications
- Model JGS524Ev2 Technical Specifications
- Installation Guide
- Smart Managed Plus Gigabit Ethernet Switches
7. Launch a web browser.
8.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 16.
The login window opens.
9. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
10.
Select System > Maintenance > Firmware Update.
The Firmware Update page displays.
The firmware update method depends on the current firmware and boot loader
versions on your switch.
11.
If the page displays the Enter Loader Mode button, click the Enter Loader Mode
button.
The switch reboots and enters into the loader mode. The Firmware Upgrade page
that displays varies, depending on the firmware boot loader version that is already
on your switch.
Follow either Step 12 or Step 13, depending on which prompts you are presented
with.
12.
If you are prompted to update the firmware from a file, click the Browse button and
locate and select the new firmware image file.
13.
If you are prompted to provide both the TFTP server IP address and the image file
name, do the following:
a.
Complete the TFTP Server IP address field.
Note: This method requires that TFTP server software is installed on your
computer to use the assigned TFTP server address from the TFTP server software
application. If TFTP server software is not installed on your computer or if you
are unsure how to do this, we recommend that you use the ProSAFE Plus Utility
to update the firmware. For more information, see the ProSAFE Plus Utility User
Manual, which you can download by visiting netgear.com/support/download/.
b.
Complete the Image File Name field.
c. Make sure that the TFTP server launches the TFTP server application.
14.
Click the Apply button.
User Manual60Manage and Monitor the Switch
Gigabit Ethernet Smart Managed Plus Switches