Owner's Manual
Table Of Contents
- User Manual
- Contents
- 1. Hardware
- 2. Get Started
- 3. Use VLANS for Traffic Segmentation
- 4. Optimize Performance With Quality of Service
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage Flow Control
- Manage the Port Speed and the Port Status
- Enable Loop Detection
- Manage Power Saving Options
- Download and Update the Firmware
- Reboot the Switch
- Save the Switch Configuration
- Restore a Saved Switch Configuration
- Restore Factory Default Settings
- Manage Access Control
- Enable Port Mirroring
- View Switch Information or Change the Switch Device Name
- View or Clear the Port Statistics
- PoE Considerations for Switches That Support PoE
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings and Technical Specifications
- Factory Default Settings
- Technical Specifications
- Model GS105Ev2 Technical Specifications
- Model GS105PE Technical Specifications
- Model GS108Ev3 Technical Specifications
- Model GS108PEv3Technical Specifications
- Model GS116Ev2 Technical Specifications
- Model GS305E Technical Specifications
- Model GS308E Technical Specifications
- Models JGS516PE and JGS524PE Technical Specifications
- Model JGS524Ev2 Technical Specifications
- Installation Guide
- Smart Managed Plus Gigabit Ethernet Switches
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the update.
For example, do not turn off the switch or disconnect it.
When the update is complete, your switch restarts. The update process typically
takes about three minutes.
Reboot the Switch
You can reboot the switch remotely.
To reboot the switch:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 16.
The login window opens.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5.
Select System > Maintenance > Device Reboot.
The Device Reboot page displays.
6. Select the check box.
7.
Click the Apply button.
The switch reboots.
Save the Switch Configuration
You can save the switch configuration as a file. We recommend that you save the
configuration. Then you can quickly restore the switch configuration if you change the
settings and then decide to return the switch to its previous settings.
User Manual61Manage and Monitor the Switch
Gigabit Ethernet Smart Managed Plus Switches