User Manual
Table Of Contents
- Contents
- 1. Hardware
- 2. Install and Access the Switch in Your Network
- 3. Optimize the Switch Performance
- 4. Use VLANS for Traffic Segmentation
- 5. Manage the Switch in Your Network
- 6. Maintain and Monitor the Switch
- Manually check for new switch firmware and update the switch
- Manage the configuration file
- Return the switch to its factory default settings
- Control access to the device UI
- Change or lift access restrictions to the switch
- Manage the DoS prevention mode
- Manage the power saving mode
- Control the port LEDs
- Change the switch device name
- View system information
- View switch connections
- View the status of a port
- PoE considerations for switches that support PoE
- Manage the PoE ports
- Display PoE port status
- Power cycle the PoE ports
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings and Technical Specifications
- B. Additional Switch Discovery and Access Information
6. In the Advanced Port-Based VLAN section, click the ADD VLAN button.
7.
Specify the settings for the new VLAN:
•
VLAN Name. Enter a name from 1 to 14 characters.
•
VLAN ID. Enter a number from 1 to the total number of ports on the switch.
•
Ports. Select the ports that you want to include in the VLAN through a combination
of the following actions:
-
Click the icon for an unselected port to add the port to the VLAN.
-
Click the icon for a selected port to remove the port from the VLAN.
- Click the Select All link to add all ports to the VLAN.
-
Click the Remove All link to remove all selected ports from the VLAN.
The icon for a selected port displays purple.
Note: If ports are members of the same LAG, you must assign them to the same
VLAN.
8. Click the APPLY button.
Your settings are saved. The new VLAN is added to the VLAN table, which shows
the port members for each VLAN.
Change an advanced port-based VLAN
You can change the settings for an existing advanced port-based VLAN.
To change an advanced port-based VLAN:
1.
Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
A login window opens.
3. Enter the device management password.
The password is the one that you specified the first time that you logged in. The
password is case-sensitive.
The HOME page displays.
4.
From the menu at the top of the page, select SWITCHING.
The QOS page displays.
5.
From the menu on the left, select VLAN.
User Manual38Use VLANS for Traffic
Segmentation
Gigabit Ethernet Plus Switches