User Manual

S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Switches
Get Started User Manual17
If you did not disable the DHCP client and assigned a static IP address to the switch,
enter 192.168.0.239.
The login window opens.
6. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
7. Select System > Management > IP Configuration.
The IP Configuration page displays.
8. Select the Static IP Address radio button.
9. Configure the IP address, subnet mask, and default gateway to be assigned to the switch.
10. Click the Apply button.
Your settings are saved.
Disconnect the Ethernet cable and return the network configuration on your computer to the
original settings.
About the User Interfaces
The switch software includes a set of comprehensive management functions for configuring
and monitoring the system by using one of the following methods:
• Local browser interface (which used to be referred to as the web interface)
• Simple Network Management Protocol (SNMP)
Each of the standards-based management methods allows you to configure and monitor the
components of the switch software. The method you use to manage the system depends on
your network size and requirements, and on your preference.
This manual describes how to use the local browser interface to manage and monitor the
system.
Software Requirements to Use the Local Browser Interface
To access the switch by using a web browser, the browser must meet the following software
requirements:
• HTML version 4.0, or later
• HTTP version 1.1, or later