User Manual

S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Switches
Configure Switching User Manual177
• Search Interface. From the Search menu, select Interface, and enter the interface ID
using the respective interface naming convention (for example, g1 or l1). Then click the
Go button.
7. T
o refresh the page with the latest information about the switch, click the Refresh button.
8. T
o clear all dynamic MAC address entries in the table, click the Clear button.
The following table describes the nonconfigurable information displayed on the page.
Table 46. MAC Address Table information
Field Description
Total MAC Address The number of MAC addresses learned or configured.
VLAN ID The VLAN ID associated with the MAC address.
MAC Address The unicast MAC address for which the switch holds forwarding and/or
filtering information.
The format is a 6-byte MAC address that is separated
by colons, for example 01:23:45:67:89:AB.
Interface The interface upon which this address was learned.
Status The status of this entry. The meanings of the values are as follows:
• Static.
The value of the corresponding instance was added by the
system or a user and cannot be relearned.
• Learned.
The value of the corresponding instance was learned, and is
being used.
• Management.
The value of the corresponding instance is also the
value of an existing instance of dot1dStaticAddress.
Set the Dynamic Address Aging Interval
You can set the address aging interval for the forwarding database.
To set the address aging interval:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser
, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Discover or Change the Switch IP
Address on page 12.
The login window opens.
4. Enter the switch’
s password in the Password field.
The default password is password.
The System Information page displays.