User Manual

S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Switches
Configure System Information User Manual73
The System Information page displays.
5. Select System > PoE > Basic > PoE Configuration.
The previous figure shows the PoE Configuration page for model GS324TP.
6. In the System Usage Threshold field, enter a number from 1 to 99 to set the threshold
level at which a trap is sent if the consumed power exceeds the threshold power
. The
default is 95 percent.
7. From the Power Management Mode menu, select the power management algorithm that
the switch uses to deliver power to the requesting powered devices (PDs):
• Static. Specifies that the power allocated for each port depends on the type of power
threshold configured on the port.
• Dynamic. Specifies that the power consumption on each port is measured and
calculated in real time. This is the default setting.
8. T
o active the PoE traps, select the Enable radio button.
Selecting the Disable radio button deactivates the PoE traps.
The default setting is
Enabled.
9. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable fields on the page.
Table 21. PoE Configuration fields
Field Description
Firmware Version The firmware version of the PoE firmware component.
Power Status The power status.
Total Power Available Watts The maximum amount of power in watts that the switch can deliver to all ports.
Threshold Power Watts If the consumed power is below the threshold power, the switch can power up
another port.
The consumed power can be between the nominal and threshold
power. The threshold power is displayed in watts.
Consumed Power Watts The total amount of power in watts that is being delivered to all ports.
Note: The threshold power value is determined by the value that you enter in the
System Usage Threshold field.