Owner's Manual

ManualsBrandsNETGEAR ManualsEthernet SwitchesGS348PP

Installation Guide

48-Port Gigabit Ethernet Unmanaged

PoE+ Switch with 24-Port PoE+ (380W)

Model GS348PP

Package contents

• Switch model GS348PP

• Power cord (varies by region)

• Rack-mount kit with four rubber feet

• Installation guide

Note: We recommend that you use Category 5e (Cat 5e) cable or higher for

Gigabit Ethernet connections.

Summary of content (6 pages)

PAGE 1
Installation Guide 48-Port Gigabit Ethernet Unmanaged PoE+ Switch with 24-Port PoE+ (380W) Model GS348PP Package contents • • • • Switch model GS348PP Power cord (varies by region) Rack-mount kit with four rubber feet Installation guide Note: We recommend that you use Category 5e (Cat 5e) cable or higher for Gigabit Ethernet connections.
PAGE 2
1. Register with the NETGEAR Insight app 1. Search for NETGEAR Insight and download the latest app. 2. Set up a NETGEAR account if you do not have one. 3. Tap the menu in the upper-left corner. 4. Tap REGISTER ANY NETGEAR DEVICE. 5. Enter the serial number located on the bottom of the switch, or use the camera on your mobile device to scan the serial number bar code. 6. Tap GO. The switch is registered and added to your account. You can now view the switch in the NETGEAR Insight app.
PAGE 3
. Check the LEDs When you connect the power cord to the switch and plug it into an electrical outlet, the LEDs indicate the status. The GS348PP provides PoE+ or PoE power on ports 1–24 up to 30W to each port, with a PoE power budget of 380W across all active PoE ports. LED Description Power On. The switch is receiving power. Off The switch is not receiving power. Ethernet (RJ Port in Link/ACT Mode) Green.1000 Mbps link on this port. Blinking. 1000 Mbps activity on this port. Yellow.
PAGE 4
PoE considerations The PoE and PoE+ power supplied by the switch is prioritized in ascending port order: Ports 1–24 support PoE and PoE+ with a total power budget of 380W. If the power requirements for the attached powered devices (PDs) exceed the total power budget of the switch, the PD on the highest-numbered port is disabled to make sure that the PDs connected to the higher-priority, lowerQXPEHUHG SRUWV DUH VXSSRUWHG ŴUVW A PD listed as an 802.
PAGE 5
PoE Troubleshooting Here are some tips for correcting PoE problems that might occur: • • If the PoE Max LED is solid yellow, disconnect one or more PoE devices to prevent PoE oversubscription. For each powered device (PD) that is connected to the switch, the associated PoE LED on the switch lights solid green. If the PoE LED lights solid yellow, a PoE fault occurred and PoE halted because of one of the conditions listed in the following table.
PAGE 6
Support Thank you for purchasing this NETGEAR product. You can visit https://www.netgear.com/support/ to register your product, get help, access the latest downloads and user manuals, and join our community. We recommend WKDW \RX XVH RQO\ RIŴFLDO 1(7*($5 VXSSRUW UHVRXUFHV Si ce produit est vendu au Canada, vous pouvez accéder à ce document en français canadien à https://www.netgear.com/support/download/. (If this product is sold in Canada, you can access this document in Canadian French at https://www.