User Manual
Table Of Contents
- Contents
- 1. Get Started
- 2. Use VLANS for Traffic Segmentation
- VLAN overview
- Create basic port-based VLANs
- Assign ports to multiple port-based VLANs
- Create 802.1Q-based VLANs in a basic configuration
- Create 802.1Q-based VLANs in an advanced configuration
- Add tagged or untagged ports to an 802.1Q-based VLAN
- Specify a port PVID for an 802.1Q-based VLAN
- Manage the voice VLAN
- 3. Optimize Performance With Quality of Service
- 4. Manage Security
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage flow control
- Manage the port speed and the port status
- Enable loop prevention
- Manage power saving options
- Manually download and upgrade the firmware
- Reboot the switch
- Save the switch configuration
- Restore a saved switch configuration
- Restore factory default settings
- Enable port mirroring
- View switch information or change the switch device name
- View or clear the port statistics
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5. Select System > Maintenance > Access Control.
6.
For a device or range of devices that must be able to access the switch, configure
the following settings:
•
Source IP Address. Enter the IP address of the device or range of devices that
must be allowed to access the switch over a web browser.
•
Mask. Enter the subnet mask that is associated with the IP address.
7. Click the Add button.
The device or range of devices is added to the table and your settings are saved.
Access control is now enabled.
8.
RepeatStep 6 andStep 7 for each device or range of devices that you want to add
to the Access Control table.
Remove devices from the Access Control table
You can remove a device from the Access Control table. If you remove all devices from
the table, access control is disabled.
To remove devices from the Access Control table:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the switch using a web
browser on page 7.
The login page displays.
4. Enter the switch password.
User Manual40Manage Security
48-Port Gigabit Ethernet Plus Switch with 2 SFP Ports Model GS750E