User Manual
Table Of Contents
- Contents
- 1. Get Started
- 2. Use VLANS for Traffic Segmentation
- VLAN overview
- Create basic port-based VLANs
- Assign ports to multiple port-based VLANs
- Create 802.1Q-based VLANs in a basic configuration
- Create 802.1Q-based VLANs in an advanced configuration
- Add tagged or untagged ports to an 802.1Q-based VLAN
- Specify a port PVID for an 802.1Q-based VLAN
- Manage the voice VLAN
- 3. Optimize Performance With Quality of Service
- 4. Manage Security
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage flow control
- Manage the port speed and the port status
- Enable loop prevention
- Manage power saving options
- Manually download and upgrade the firmware
- Reboot the switch
- Save the switch configuration
- Restore a saved switch configuration
- Restore factory default settings
- Enable port mirroring
- View switch information or change the switch device name
- View or clear the port statistics
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5. Select System > Management > Switch Management Mode.
The Switch Management Mode page displays.
6.
Select one of the following radio buttons:
•
Web browser Only. You can configure the switch through the local browser
interface only.
•
Web browser GUI and ProSAFE Utility. You can configure the switch through
the local browser interface or through the ProSAFE Plus Utility. This is the default
setting. However, the ProSAFE Plus Utility has reached end-of-life and is no longer
supported.
7. Click the Apply button.
Your settings are saved.
Disable Bonjour for discovery
By default, the Bonjour protocol is enabled on the switch to allow for native discovery
on macOS devices. For additional security, you can disable Bonjour on the switch,
preventing macOS devices from discovering the switch.
To disable Bonjour on the switch:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the switch using a web
browser on page 7.
The login page displays.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
User Manual42Manage Security
48-Port Gigabit Ethernet Plus Switch with 2 SFP Ports Model GS750E