User Manual
Table Of Contents
- Contents
- 1. Get Started
- 2. Use VLANS for Traffic Segmentation
- VLAN overview
- Create basic port-based VLANs
- Assign ports to multiple port-based VLANs
- Create 802.1Q-based VLANs in a basic configuration
- Create 802.1Q-based VLANs in an advanced configuration
- Add tagged or untagged ports to an 802.1Q-based VLAN
- Specify a port PVID for an 802.1Q-based VLAN
- Manage the voice VLAN
- 3. Optimize Performance With Quality of Service
- 4. Manage Security
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage flow control
- Manage the port speed and the port status
- Enable loop prevention
- Manage power saving options
- Manually download and upgrade the firmware
- Reboot the switch
- Save the switch configuration
- Restore a saved switch configuration
- Restore factory default settings
- Enable port mirroring
- View switch information or change the switch device name
- View or clear the port statistics
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings
Set up a static link aggregation group
The switch can support eight LAGs, which can be a combination of static link aggregation
and LACP groups.
You must set up LAG membership before you can enable LAGs.
To specify LAG membership for a static LAG and enable a static LAG:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the switch using a web
browser on page 7.
The login page displays.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5. Select System > LAG > LAG Membership.
6. In the LAG ID menu, select the LAG ID.
You can select a LAG ID from 1 to 8.
7.
Enter a name in the LAG Name field.
You can enter a name of up to 15 alphanumeric characters.
8.
Select the ports for the LAG by selecting the check boxes that are associated with
the port numbers.
A LAG consists of at least two ports.
9. Click the Apply button.
Your settings are saved.
User Manual52Manage Network Settings
48-Port Gigabit Ethernet Plus Switch with 2 SFP Ports Model GS750E