User Manual
Table Of Contents
- Contents
- 1. Get Started
- 2. Use VLANS for Traffic Segmentation
- VLAN overview
- Create basic port-based VLANs
- Assign ports to multiple port-based VLANs
- Create 802.1Q-based VLANs in a basic configuration
- Create 802.1Q-based VLANs in an advanced configuration
- Add tagged or untagged ports to an 802.1Q-based VLAN
- Specify a port PVID for an 802.1Q-based VLAN
- Manage the voice VLAN
- 3. Optimize Performance With Quality of Service
- 4. Manage Security
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage flow control
- Manage the port speed and the port status
- Enable loop prevention
- Manage power saving options
- Manually download and upgrade the firmware
- Reboot the switch
- Save the switch configuration
- Restore a saved switch configuration
- Restore factory default settings
- Enable port mirroring
- View switch information or change the switch device name
- View or clear the port statistics
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings
5. Select System > Management > Port Status.
6. Select one or more ports.
7.
In the Speed menu, select one of the following options:
•
Auto. The port speed is set automatically after the switch determines the speed
using autonegotiation with the link partner. This is the default setting.
•
Disable. The port is shut down.
•
10M Half. The port is forced to function at 10 Mbps with half duplex.
•
10M Full. The port is forced to function at 10 Mbps with full duplex.
•
100M Half. The port is forced to function at 100 Mbps with half duplex.
•
100M Full. The port is forced to function at 100 Mbps with full duplex.
8.
To configure more ports, repeat this procedure from Step 6 on.
9. Click the Apply button.
Your settings are saved.
Enable loop prevention
If loop prevention is enabled and the switch detects a loop, the switch blocks one of
the ports that are part of the loop and both LEDs of that port blink at a constant speed.
If two ports are part of a loop, the port with the highest port number is blocked. For
example, if port 1 and port 2 are part of a loop, port 2 is blocked while port 1 continues
User Manual61Manage and Monitor the Switch
48-Port Gigabit Ethernet Plus Switch with 2 SFP Ports Model GS750E