User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual122
You take one of the following actions:
• In the Go T
o Interface field, enter the interface in unit/slot/port format and click the Go
button. The entry corresponding to the specified interface is selected.
• Select the check box from the list of Interfaces configured for DHCPv6 Relay
functionality
.
6. In the Admin mode field, specify the DHCPv6 mode, either Enable or Disable, to configure
DHCPv6 Relay functionality
.
The default is Disable. DHCPv6 server and DHCPv6 relay functions are mutually
exclusive.
7. From the Relay Interface list, select an interface to reach a relay server
.
8. In the Destination IP
Address, specify an IPv6 address to reach a relay server.
9. In the Remote ID field, specify the relay agent information option.
The remote ID is derived from the DHCPv6 server DUID and the relay interface number,
or it can be specified as a user-defined string.
10. Click the Apply button.
Your settings are saved.
Configure Power over Ethernet
Note: Power over Ethernet (PoE) is supported on models M4300-16X,
M4300-28G-POE+, M4300-52G-POE+, and M4300-96X. The latter
model requires one or more APM408 port cards.
Configure Basic PoE Settings
To configure basic PoE settings:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select System > PoE > Basic > PoE Configuration.