User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual123
The Unit field displays the current PoE switch unit number. The Slot field displays the
current PoE slot number for model M4300-96X.
5. To configure the settings for a PoE switch unit, select the check box for the switch unit
number.
6. From the Power Management mode menu, select the power management algorithm that
the switch uses to deliver power to the requesting PDs:
• Static. Select Static to specify that the power allocated for each port depends on the
type of power threshold that is configured on the port.
• Dynamic. Select Dynamic to specify that the power consumption on each port is
measured and calculated in real time.
7. T
o set the traps, from the PoE Trap Configuration menu, select Enable to activate the PoE
traps or Disable to deactivate the PoE traps.
The default setting is enabled.
8. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable fields on the page.
Table 43. Nonconfigurable fields on the basic PoE Configuration page
Field Description
Model The model of the PoE port card.
Host The switch in which the PoE port card is installed.
Status The status of the PoE port card.
Firmware Version The firmware version of the PoE software.
Power Status Indicates the power status.
Total Power (Main AC) The maximum power in watts the switch can deliver to all ports. If N/A is displayed,
the power supply is not present.