User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual144
Configure LLDP-MED Global Settings
You can specify LLDP-MED parameters that are applied to the switch.
To configure LLDP-MED global settings:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select System > LLDP > LLDP-MED > Global Configuration.
5. In the Fast Start Repeat Count field, enter the number of LLDP PDUs that are transmitted
when the protocol is enabled.
The range is from (1 to 10). Default value of fast repeat count is 3.
The Device Class field specifies local device's MED classification.
There are four
different kinds of devices, three of them represent the actual end points (classified as
Class I Generic [IP Communication Controller and so on], Class II Media [Conference
Bridge and so on], Class III Communication [IP Telephone and so on]). The fourth device
is Network Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1
Bridge, IEEE 802.11 Wireless Access Point and so on.
6. Click the Apply button.
Your settings are saved.
System Name Specifies model name of the remote device.
Remote Port ID The port component associated with the remote system.
Table 49. LLDP Remote Device Inventory (continued)
Field Description