User Manual

Table Of Contents
M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Stacking User Manual171
The following table describes the nonconfigurable Stack Configuration fields.
The following table describes the nonconfigurable Stack Status information that is displayed.
Table 59. Stack Configuration
Field Description
Hardware Management
Preference
The hardware management preference of the switch. The hardware
management preference can be disabled or unassigned.
Standby Status Identifies the switch that is configured as the standby unit. The possible
values are as follows:
• Cfg Standby. Indicates that the unit is configured as the standby unit.
The unit configured as the standby switch becomes the stack manager if
the current manager fails.
• Opr Standby. Indicates that this unit is operating as the standby unit
and the configured standby unit is not part of the stack.
• None. The
switch is not configured as the standby unit.
Switch Status The status of the selected unit. The possible values are as follows:
• OK. The
unit is connected and works properly.
• Unsupported.
The type of inserted unit is not supported.
• Code Mismatch.
The firmware version is not identical to the master or
management unit.
• Config Mismatch.
The inserted device type is different from the
configured devices.
• Not Present. The
unit is not connected.
• SDM Mismatch.
The SDM template does not match.
• Updating Code. A
firmware update is in progress.
• STM Mismatch. The
STM template does not match.
Table 60. Stack Status nonconfigurable fields
Field Description
Hardware Management
Preference
The hardware management preference of the switch, which can be
disabled or unassigned.
Standby Status Identifies the switch that is configured as the standby unit:
• Cfg Standby
. The unit is configured as the standby unit. The unit
configured as the standby switch becomes the stack manager if
the current manager fails.
• Opr Standby
. This unit is operating as the standby unit and the
configured standby Unit is not part of the stack.
• None. The
switch is not configured as the standby unit.