User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual186
4. Select Switching> VLAN > Advanced > VLAN Trunking Configuration.
5. T
o specify which interfaces are displayed on the page, select one of the following options:
• Select the Unit ID field to display physical port information for the selected unit.
• Use LAG to display LAGs only.
• Use All to display all physical ports.
6. Use one of the following methods to select an interface:
• Use Go T
o Interface to select an interface by entering its number.
• Use Interface to select the interface for which data is to be displayed or configured.
7. In the Switchport Mode list, select one of the following:
• Access.
This mode is suitable for ports connected to end stations or end users.
Access ports participate in only one VLAN. They accept both tagged and untagged
packets, but always transmit untagged packets.
• Trunk.
This mode is intended for ports that are connected to other switches. Trunk
ports can participate in multiple VLANs and accept both tagged and untagged
packets.
• General.
This mode enables custom configuration of a port. You configure the
general port VLAN attributes, such as membership, PVID, tagging, ingress filter, and
so on, using the settings on the Port Configuration page. By default, all ports are
initially configured in General mode.
• Host.
This mode is used for private VLAN configuration.
• Promiscuous.
This mode is used for private VLAN configuration.
8. Select from the list to configure the Access VLAN ID.
This is the access VLAN for the port, and is valid only when the port switchport mode is
Access.