User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual241
The System Information page displays.
4. Select Switching> Multicast > IGMP Snooping > Interface Configuration.
The page lists all physical, VLAN, and LAG interfaces.
5. Use one of the following methods to select an interface:
• In the Go T
o Interface field, enter the interface in the unit/slot/port format and click on
the Go button.
• Next to the Interface column, select the check box for the interface that you want to
configure
6. From the Admin Mode menu, select Disable or Enable.
This selection enables or disables the administrative mode for IGMP snooping for the
interface.
The default is Disable.
7. In the Membership Interval field, specify the period that the switch waits for a group report
before it removes the interface as a member of the group.
Enter a value between 1 and 3600 seconds. The default is 600 seconds.
8. In the Max Response T
ime field, specify the period that the switch waits after it sent a query
on an interface because it did not receive a report from a group on that interface.
Enter a value that is 1 or greater but less than the value in the Membership Interval field.
The default is 120 seconds.
9. In the Expiration T
ime field, specify the period that the switch waits to receive a query on
the interface before it removes the interface from the list of interfaces with multicast routers
attached.
Enter a value between 0 and 3600 seconds. The default is 0 seconds, which indicates an
infinite time-out (no expiration).