User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual243
• Proxy Querier
• Querier Election Mode
• Installs reserved Multicast MAC addresses into the system.
If disabled, these IGMP snooping modes are automatically disabled for the VLAN.
Note: For information about other settings on the page, see
Configure IGMP
Snooping for VLANs Manually on page 243.
7. Click the Apply button.
Your settings are saved.
Configure IGMP Snooping for VLANs Manually
You can manually configure the settings for IGMP snooping for VLANs, which is used to build
forwarding lists for multicast traffic. You can also configure IGMP snooping for VLANS
automatically (see
Configure IGMP Snooping for VLANs Automatically with IGMP Plus
Mode on page 242).
To configure the settings for IGMP snooping for VLANs manually:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching> Multicast > IGMP Snooping > IGMP VLAN Configuration.
5. T
o enable IGMP snooping on a VLAN, do the following:
a. Select the check box next to the VLAN ID.
b. Configure the IGMP snooping settings:
• Admin Mode. From the menu, select to enable or disable IGMP snooping for the
VLAN.
The default is Disable.
• Fast Leave. From the menu, select to enable or disable the IGMP snooping fast
leave mode for the VLAN.
This selection enables or disables the automatic
assignment of fast-leave messages for all members of the VLAN. The default is
Enable.