User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual245
7. To modify the IGMP snooping settings for a VLAN manually, do the following:
a. Select the check box next to the VLAN ID
b. Update the settings.
c. Click the Apply button.
Your settings are saved.
Configure a Multicast Router
You can configure the interface as the one the multicast router is attached to. All IGMP
packets snooped by the switch are forwarded to the multicast router reachable from this
interface. The configuration is not needed most of the time since the switch automatically
detects the multicast router and forwards IGMP packets accordingly. It is needed only if you
want to make sure that the multicast router always receives IGMP packets from the switch in
a complex network.
To configure a multicast router:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching> Multicast > IGMP Snooping > Multicast Router Configuration.
5. Use Interface to select the physical interface.
6. In the Multicast Router field, select Enable or Disable.
7. Click the Apply button.
Your settings are saved.