User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual264
6. Use the MVR Multicast VLAN to specify the VLAN on which MVR multicast data is
received.
All source ports belong to this VLAN. The value can be set in a range of 1 to 4094. The
default value is 1.
7. Use the MVR Global query response time to set the maximum time to wait for the IGMP
reports membership on a receiver port.
This time applies only to receiver-port leave
processing. When an IGMP query is sent from a receiver port, the switch waits for the
default or configured MVR query time for an IGMP group membership report before
removing the port from the multicast group membership. The value is equal to the tenths of
second. The range is from 1 to 100 tenths. The factory default is 5 tenths or one-half.
8. Select a MVR Mode radio button to specify the MVR mode of operation.
The factory default is compatible.
9. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information displayed on the page.
Configure an MVR Group
To configure an MVR group:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching > MVR >
Advanced > MVR Group Configuration.
Table 94. Advanced MVR Configuration
Field Definition
MVR Max Multicast Groups The maximum number of multicast groups that MVR supports.
MVR Current Multicast Groups Displays the current number of MVR groups allocated.