User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual270
• Searched by VLAN ID. Select VLAN ID, enter the VLAN ID, for example, 100. Then
click the Go button. If the address exists, the entry is displayed as the first entry
followed by the remaining (greater) MAC addresses.
• Searched by Port. Select Port, enter the port ID in Unit/Slot/Port format, for example,
2/1/1. Then
click the Go button. If the address exists, the entry is displayed as the first
entry followed by the remaining (greater) MAC addresses.
The following table describes the nonconfigurable information displayed on the page.
Set the Dynamic Address Aging Interval
You can set the address aging interval for the specified forwarding database.
To set the address aging interval:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching
> Address Table> Advanced > Dynamic Addresses.
Table 97. Basic Address Table
Field Description
Total MAC Address Displaying the number of total MAC addresses learned or configured.
MAC Address A unicast MAC address for which the switch has forwarding and/or filtering
information.
The format is a 6 byte MAC address that is separated by
colons, for example 01:23:45:67:89:AB.
VLAN ID The VLAN ID associated with the MAC address.
Port The port upon which this address was learned.
Status The status of this entry. The meanings of the values are as follows:
• Static.
The value of the corresponding instance was added by the
system or a user and cannot be relearned.
• Learned.
The value of the corresponding instance was learned, and is
being used.
• Management.
The value of the corresponding instance is also the value
of an existing instance of dot1dStaticAddress.