User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual277
• Auto-Recovery Admin Mode. Select the Enable or Disable radio button.
This setting determines the auto-recovery administrative mode. To enable
auto-recovery
, you must select Enable. The default is Disable.
If enabled, the port is automatically removed from the disabled state after the interval
is reached.
• Auto-Recovery Interval. Enter the period in seconds after which the port is
automatically removed from the disabled state. The default period is 300 seconds.
You can enter a period from 30 to 8640 seconds. This setting applies only if the
Auto-Recovery Admin Mode radio button is selected.
6. Click the Apply button.
Your settings are saved.
The D-Disabled Ports due to Link Flap section lists the ports that are in the disabled state.
Configure Port Descriptions
To configure and display the description for all ports in the device:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching > Ports > Port Description.
5. Use Port Description to enter the description string to be attached to a port.
It can be up to 64 characters in length.