User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual286
individual MAC address information and group MAC address membership. End stations
can request to join or leave a multicast group, or to register an individual MAC address
with a specific VLAN. MAC address entries can be dynamically registered and
deregistered if MMRP is administratively enabled on the device.
7. Select the Periodic State Machine (MVRP) Enable or Disable radio button.
When enabled, the state machine can help limit the effect of topology changes and
reduce the number of protocol data units (PDUs) transmitted between devices.
The
default is Disable.
8. Select the Periodic State Machine (MMRP) Enable or Disable radio button.
When enabled, the state machine can help limit the effect of topology changes and
reduce the number of protocol data units (PDUs) transmitted between devices.
The
default is Disable.
9. Click the Apply button.
Your settings are saved.
Configure MRP Port Settings
You can configure the per-port MRP mode and timer settings. The timers control when and
how often various messages are transmitted on each interface.
To configure MRP port settings:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching> MRP > Advanced > Port Settings.