User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual292
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching> L2 Loop Protection > L2 Loop Protection Configuration.
5. In the Global L2 Loop Protection Configuration section, configure the following settings:
• Next to
Admin Mode, select the Enable or Disable radio button to specify the
administrative mode of loop protection on the switch.
By default, loop protection is globally disabled.
• From the T
ransmit Interval menu, select the interval between the transmissions of
loop packets on a port.
The range is from 1 to 5 seconds. The default setting is 5 seconds. The selected
interval applies to all ports for which you enable loop protection.
• From the Max PDU Receive menu, select the maximum number of packets that a
port can receive before an action is taken.
The default setting is 1 packet. The selected number of packets applies to all ports for
which you enable loop protection.
6. Click the Apply button.
Your settings are saved.