User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Routing User Manual302
Configure the Routing IP Settings
You can configure routing IP settings for the switch, as opposed to the IP settings for an
interface.
To configure the routing IP settings:
1. Launch a web browser.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing> IP > Basic > IP Configuration.
5. Use Routing Mode to select Enable or Disable.
You must enable routing for the switch before you can route through any of the interfaces.
The default value is Disable.
6. Use ICMP Echo Replies to select Enable or Disable.
If you select Enable, then only the router can send ECHO replies. By default ICMP Echo
Replies are sent for echo requests.
7. Use ICMP Redirects to select Enable or Disable.
If this is enabled globally and on an interface level, then only the router can send ICMP
Redirects.
8. Use ICMP Rate Limit Interval to control the ICMP error packets by specifying the number
of ICMP error packets that are allowed per burst interval.