User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Routing User Manual307
Configure Routing Parameters for the
Switch
You can configure routing parameters for the switch as opposed to an interface.
To configure routing parameters for the switch:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing> IP >
Advanced > IP Configuration.
5. Use Routing Mode to select Enable or Disable.
You must enable routing for the switch before you can route through any of the
interfaces.
The default value is Disable.
6. Use ICMP Echo Replies to select Enable or Disable.
If you select Enable, then only the router can send ECHO replies. By default ICMP echo
replies are sent for echo requests.
7. Use ICMP Redirects to select Enable or Disable.
If it is enabled globally and on interface level then only the router can send ICMP
redirects.