User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Routing User Manual341
• None. Selected if the user does not want to delete any entry from the ARP Table.
• Remove IP Address.
This field displays only if you select Specific
Dynamic/Gateway Entry or Specific Static Entry in the Remove from Table list.
The Remove IP Address field allows you to enter the IP address against the entry
that is to be removed from the ARP table.
11. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information displayed on the page.
Configure RIP
Enable RIP
To enable RIP:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing > RIP > Basic > RIP Configuration.
Table 121. ARP Table Configuration
Field Description
Total Entry Count Total number of entries in the ARP table.
Peak Total Entries Highest value reached by Total Entry Count. This counter value is
restarted whenever the
ARP table Cache Size value is changed.
Active Static Entries Total number of active static entries in the ARP table.
Configured Static Entries Total number of configured static entries in the ARP table.
Maximum Static Entries Maximum number of static entries that can be defined.