User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Routing User Manual346
To configure advanced RIP route redistribution settings:
1. Launch a web browser.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing > RIP >
Advanced > Route Redistribution.
The Source list is populated by only those source routes that are already configured for
redistribution by RIP. This allows you to configure another source route among the
available source routes.
5. In the Source list, select a value.
The valid values are as follows:
• Connected
• Static
• OSPF
6. From the Redistribute Mode list, select to Enable or Disable RIP redistribute mode.
The default is Disable.
7. Enter the Metric of redistributed routes for the given source route.
The valid values are is 0 to 15; 0 means unconfigure.
8. Use the Distribute List field to set the access list that filters the routes to be redistributed by
the destination protocol.
Only permitted routes are redistributed. If this command refers to a non-existent access
list, all routes are permitted.
The valid values for Access List IDs are 0 to 199. When used
for route filtering, the only fields in an access list that get used are as follows:
• Source IP address and netmask