User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure OSPF and OSPFv3 User Manual371
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing > OSPF >
Advanced > Interface Configuration.
5. Use one of the following methods to select an interface:
• In the Go T
o Interface field, enter the interface in the unit/slot/port format and click on
the Go button.
• Next to the Interface column, select the check box for the interface that you want to
configure.
6. In the OSPF Area ID field, enter the 32-bit integer in dotted-decimal format.
This ID uniquely identifies the OSPF area to which the selected router interface connects.
If you assign an area ID that does not exist, the area is created with default values.
7. In the Admin Mode list, select Enable or Disable.
The default value is Disable.
You can configure OSPF parameters without enabling
OSPF admin mode, but the change does not take effect until you enable admin mode.
The following information is displayed only if admin mode is enabled: