User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure OSPF and OSPFv3 User Manual380
View the OSPF Link State Database
To view the OSPF link state database:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing > OSPF >
Advanced > Link State Database.
5. To refresh the page with the latest information on the switch, click the Refresh button.
The following table describes the nonconfigurable information that is displayed.
Table 136. OSPF Link State Database
Field Description
Router ID The 32-bit integer in dotted-decimal format that uniquely identifies the
router within the autonomous system (AS).
The router ID is set on the IP
Configuration page. To change the router ID you must first disable OSPF.
After you set the new router ID, you must reenable OSPF for the change to
take effect. The default value is 0.0.0.0, although this is not a valid router
ID.
Area ID The ID of an OSPF area to which one of the router interfaces is connected.
An area ID is a 32-bit integer in dotted-decimal format that uniquely
identifies the area to which an interface is connected.