User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure OSPF and OSPFv3 User Manual387
4. Select Routing > OSPF > Advanced > Route Redistribution.
5. From the Source menu, select from the list of available source routes that were not
previously configured for redistribution by OSPF
.
The valid values are as follows:
• BGP
• Connected
• OSPF
• RIP
• Static
6. In the Redistribute list, select to Enable or Disable the redistribution for the selected
source protocol.
7. Set the Metric value to be used as the metric of redistributed routes.
This fields displays the metric if the source was preconfigured and can be modified. The
valid values are 0 to 16777214.
8. From the Metric T
ype list, select the OSPF metric type of redistributed routes.
9. Set the Ta
g field in routes redistributed.
This field displays the tag if the source was preconfigured; otherwise, the tag is 0 and can
be modified.
The valid values are 0 to 4294967295.
10. From the Subnets list, select whether the subnetted routes will be redistributed (Enable) or
not (Disable).
11. In the Distribute List field, set the access list that filters the routes to be redistributed by the
destination protocol.
Only permitted routes are redistributed. If this command refers to a nonexistent access
list, all routes are permitted.
The valid values for access list IDs are 1 to 199.
When used for route filtering, the only fields in an access list that get used are as follows:
• Source IP address and netmask
• Destination IP address and netmask
• Action (permit or deny)
All other fields (source and destination port, precedence, ToS, and so on) are ignored.