User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure OSPF and OSPFv3 User Manual391
5. Select the Admin Mode Disable or Enable radio button.
If you select Enable, OSPFv3 is activated for the switch. By default, OSPFv3 is enabled.
Y
ou must configure a router ID before OSPFv3 can become operational. For more
information, see
Configure the Routing IP Settings on page 302.
Note: Once OSPFv3 is initialized on the router, it remains initialized until the
router is reset.
6. Enter the Router ID as a 32-bit integer in dotted-decimal format that uniquely identifies the
router within the autonomous system (AS).
To change the router ID, you must first disable OSPFv3. After you set the new router ID,
you must reenable OSPFv3 for the change to take ef
fect. The default value is 0.0.0.0,
although this is not a valid router ID.
7. Click the Apply button.
Your settings are saved.
Configure OSPFv3 Default Route Advertise Settings
1. Launch a web browser.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing > OSPFv3 >
Advanced > OSPFv3 Configuration.