User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure OSPF and OSPFv3 User Manual415
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing > OSPFv3 >
Advanced > Route Redistribution.
5. From the Source menu, select from the list of available source routes that were not
previously configured for redistribution by OSPFv3.
The valid values are as follows:
• Connected
• Static
6. In the Redistribute Option list, select to Enable or Disable the redistribution for the
selected source protocol.
7. Set the Metric value to be used as the metric of redistributed routes.
This fields displays the metric if the source was preconfigured; otherwise, the tag is 0 and
can be modified.
The valid values are 0 to 16777214.
8. From the Metric Type list, select the OSPFv3 metric type of redistributed routes.
9. Set the Ta
g field in routes redistributed.
This field displays the tag if the source was preconfigured; otherwise, the tag is 0 and can
be modified.
The valid values are 0 to 4294967295.
10. Click the Apply button.
Your settings are saved.
View the NSF OSPFv3 Summary
You can view the NSF OSPFv3 summary. The allowable values for each field are displayed
next to the field. If any invalid values are entered, an alert message is displayed with the list
of all the valid values.
To view the NSF OSPF summary:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.