User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Multicast Routing User Manual426
Search for DVMRP Neighbors
To search for DVMRP neighbors:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing> Multicast > DVMRP > DVMRP Neighbor.
5. Use the Search menu to search for neighbor entries by MAC interface or neighbor IP
address:
• Select Interface from the menu, enter the interface in unit/slot/port format (for
example 1/0/13), and click the Go button.
If the neighbor entry exists, the entry is displayed as the first entry, followed by the
remaining entries.
• Select Neighbor IP from the menu, enter the neighbor IP address, and click the Go
button.
If the entry with the matching neighbor IP exists, the entry is displayed as the first
entry, followed by the remaining entries. An exact match is required.
The following table describes the nonconfigurable information that is displayed.
Table 157. DVMRP Neighbor
Field Description
Interface Select the interface for which data is to be displayed, or all the
interfaces are displayed.
Neighbor IP The IP address of the neighbor whose information is displayed
State The state of the specified neighbor router on the selected interface,
either active or down.
Up Time The DVMRP uptime for the specified neighbor on the selected
interface.
This is the time since the neighbor entry was learned.