User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Multicast Routing User Manual430
Configure Multicast IGMP Settings
You can configure IGMP settings and view IGMP statistics.
Configure IGMP Global Settings
To configure the IGMP global settings:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing> Multicast > IGMP > Global Configuration.
5. In the Admin Mode field, select the Enable or Disable option.
This sets the administrative status of IGMP in the router to active or inactive. The default
is Disable.
Interface The interface on which IP datagrams sent by these sources are
received. A value of 0 typically means the route is an aggregate for
which no next-hop interface exists.
Metric The distance in hops to the source subnet.
Expiry Time The amount of time remaining before this prune expires at the
upstream neighbor
. If no prune messages were received from
downstream neighbors, this is set to value of the default prune lifetime
timer, otherwise it is set to the smallest received value or the default
timer, whichever is less.
Up Time The time since the route represented by this entry was learned by the
router
.
Table 160. DVMRP Route (continued)
Field Description