User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Multicast Routing User Manual437
3. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing> Multicast > IGMP > Proxy Interface Configuration.
5. Use the Interface list to select the port.
At least one router interface must be configured before you configure or display data for
an IGMP proxy interface, and it must not be an IGMP routing interface.
6. Select Enable or Disable from the
Admin Mode list.
This sets the administrative status of IGMP proxy on the selected interface. The default is
Disable. Routing, IGMP and Multicast global admin modes must be enabled to enable
IGMP proxy interface mode.
7. In the Unsolicited Report Interval field, enter the unsolicited time interval value in seconds.
The unsolicited report interval is the time between repetitions of a host's initial report of
membership in a group. V
alid values are from 1 to 260. The default value is 1.
8. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information that is displayed.
Table 164. Multicast IGMP Proxy Interface Configuration
Field Description
IP Address The IP address of the IGMP proxy interface.
Subnet Mask The subnet mask for the IP address of the IGMP proxy interface.