User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Multicast Routing User Manual443
• Next to the Interface column, select the check box for the interface that you want to
configure.
6. In the Admin Mode field, select the Enable or Disable option to set the administrative
status of PIM in the router
.
The default is Disable.
7. In the Hello Interval field, enter the time in seconds between the transmission of PIM hello
messages on this interface.
The valid values are from 0 to 18000. The default value is 30.
8. In the Join/Prune Interval, enter the time in seconds at which PIM Join/Prune messages
are transmitted on this PIM interface.
The valid values are from 0 to 18000. The default
value is 60.
9. In the BSR Border field, select the Enable or Disable option to set the bootstrap router
(BSR) border status on the selected interface.
10. Enter the DR Priority for the selected interface.
The valid values are from 0 to 2147483647. The default value is 1.
11. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information that is displayed.
View the PIM Neighbor
To view the PIM neighbor:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
Table 167. Multicast PIM Interface Configuration
Field Description
Protocol State The state of PIM in the router. either Operational or Non-Operational.
IP Address The IP address of the selected PIM interface. If you enter an IPv6
address, the format is prefix/prefix length.
Designated Router The designated router on the selected PIM interface.
Neighbor Count The number of PIM neighbors on the selected interface.