User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Multicast Routing User Manual454
Configure the IPv6 PIM Interface
To configure the IPv6 PIM interface:
1. Launch a web browser.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing> IPv6 Multicast > IPv6 PIM > Interface Configuration.
5. Use one of the following methods to select an interface:
• In the Go T
o Interface field, enter the interface in the unit/slot/port format and click on
the Go button.
• Next to the Interface column, select the check box for the interface that you want to
configure.
6. In the Admin Mode field, select Enable or Disable.
This sets the administrative status of PIM-SM in the router. The default is Disable.
7. In the Hello Interval field, enter the time in seconds between the transmission of PIM hello
messages on this interface.
The valid values are from 0 to 18000. The default value is 30.
8. In the Join/Prune Interval field, enter the frequency at which PIM Join/Prune messages are
transmitted on this PIM interface.
The valid values are from 0 to 18000. The default value is 60.
9. In the BSR Border field, select the Enable or Disable option to set the bootstrap router
(BSR) border status on the selected interface.
10. Enter the DR Priority for the selected interface.
The valid values are from 0 to 2147483647. The default value is 1.