User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Multicast Routing User Manual458
The following table describes the nonconfigurable information that is displayed.
Configure the IPv6 PIM Static Rendezvous Point
You can statically configure the rendezvous point (RP) address for one or more multicast
groups.
To configure the IPv6 PIM static RP:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing> IPv6 Multicast > IPv6 PIM > Static RP Configuration.
5. In the RP Address field, enter the IP address of the RP
.
6. In the Group Address field, enter the address of the RP
.
7. In the Prefix Length field, enter the group address prefix length.
8. In the Override field, select Enable or Disable.
Enable indicates that, if there is a conflict, the RP configured with this option prevails over
the RP learned by BSR.
Table 175. IPv6 PIM BSR Candidate Configuration
Field Description
BSR Expiry Time (hh:mm:ss) Time (in hours, minutes and seconds) in which the learned elected
bootstrap router (BSR) expires.
IP Address The IP address of the elected BSR.
Next bootstrap Message
(hh:mm:ss)
Time (in hours, minutes, and seconds) in which the next bootstrap
message is due from this BSR.
Next Candidate RP Advertisement
(hh:mm:ss)
Time (in hours, minutes, and seconds) in which the next candidate RP
advertisement is sent.