User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Multicast Routing User Manual460
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing> IPv6 Multicast > MLD > Routing Interface Configuration.
5. Use one of the following methods to select an interface:
• In the Go T
o Interface field, enter the interface in the unit/slot/port format and click on
the Go button.
• Next to the Interface column, select the check box for the interface that you want to
configure.
6. In the Admin Mode field, select Enable or Disable.
This sets the administrative status of MLD on the selected routing interface. The default is
Disable.
7. In the V
ersion field, enter the version to configure for the selected interface.
Valid values are 1 to 2. The default value is 2.
8. In the Query Interval field, enter the frequency in seconds at which MLD host-query packets
are to be transmitted on this interface.
Valid values are 1 to 3600. The default value is 125.
9. In the Query Max Response T
ime field, enter the maximum query response time, in
milliseconds, to be advertised in MLDv2 queries on this interface.
Valid values are 0 to 65535. The default value is 10000 milliseconds.
10. In the Startup Query Interval field, enter the configured interval in seconds between
general queries sent by a querier on startup.
The default value is 31.