User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Quality of Service User Manual475
Configure CoS Interface Settings for an Interface
You can apply an interface shaping rate to all interfaces or to a specific interface.
To configure CoS settings for an interface:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select QoS > CoS>
Advanced > CoS Interface Configuration.
5. Select one of the following options to specify which interfaces are displayed on the page:
• Select LAG to show the list of all LAG interfaces.
• Select All to show the list of all physical as well as LAG interfaces.
6. Use one of the following methods to select an interface:
• Use the Go T
o Interface field to enter the interface in unit/slot/port format and click
the Go button.
The entry corresponding the specified interface is selected.
• Select an interface from the Interface list of all CoS configurable interfaces.
7. Use Interface T
rust Mode to specify whether or not to trust a particular packet marking at
ingress.
Interface Trust Mode can be one of the following:
• Untrusted
• 802.1p
• IP DSCP